The red light on the scr can be a sign of a problem in the QLS sensor. This is a very simple fix. You just need to connect the unit to a scanner. The NOX levels can be monitored to determine if your QLS sensor check here is defective. If you have any questions about where by in addition to how you can work with scr system altered or fault detected peterbilt, you’ll be able to contact us from our own webpage.
PSSR can help fix scr system fault
If you are trying to fix a SCR system fault, you may not be able to diagnose the exact cause. Many times, the problem could be caused by multiple factors. The most common cause is a loose connection. This can cause high voltage spikes and electrical noise. These can damage the logic circuits and shorten the life of the SCRs. Another common cause of SCR failures is erratic gate signals. This can lead to tripping of the device failure.
QLS sensor
You might need to replace your QLS sensor if your truck is experiencing problems with its QLS sensor. The QLS sensors are critical to maintain truck DEF quality. The QLS sensor is not a difficult replacement. Connecting the unit to a scanner that monitors NOX levels is the first step.
Failing the QLS sensor can cause the truck’s to malfunction and check here will result in a fault code appearing on the screen. If this happens, contact your local Cummins Authorized Services Location. A replacement sensor is not always available right away in many cases.
Engine control module
An ECM failure can lead to a host of symptoms. The crank-no-start symptom is one example. It can occur while driving or when the car is stopped. It is important to replace the ECM as soon as possible if this happens. You could end up with a dead vehicle.
Excessive fuel consumption is another sign. ECM faults may also result in poor acceleration or lack of power. You probably have any type of questions pertaining to where and ways to utilize engine will derate in 60 minutes, you could call us at our own page.